Recently presented RF cavity prototypes printed entirely from pure copper illustrate the potential of additive manufacturing (AM), and particularly laser powder bed fusion (L-PBF), for accelerator technology. Thereby, the design freedom of L-PBF is only limited by overhanging geometries, which have to be printed with supporting structures to ensure sufficient accuracy. However, the subsequent removal of these support structures is a major challenge for cm-sized GHz cavities. Therefore, our approach is to design self-supporting geometries. In this contribution, we present a drift tube cavity geometry as used in e.g. proton therapy linac systems that can be fabricated by L-PBF without support structures. A 5-cell prototype was manufactured from high-purity copper using L-PBF. It is shown that the developed geometry allows a print accuracy sufficient to reach the defined resonance frequency. A chemical, as well as a dynamic electrochemical finishing process, was applied to optimize the prototype’s surface quality. Thus, the CST simulated 𝑄0 was obtained for the first time with a printed copper cavity.     «

Recently presented RF cavity prototypes printed entirely from pure copper illustrate the potential of additive manufacturing (AM), and particularly laser powder bed fusion (L-PBF), for accelerator technology. Thereby, the design freedom of L-PBF is only limited by overhanging geometries, which have to be printed with supporting structures to ensure sufficient accuracy. However, the subsequent removal of these support structures is a major challenge for cm-sized GHz cavities. Therefore, our appr...     »